D25-LT Lamp Issues

Follow

We are having problems with our D25-LT lamp. When we install a new lamp the lamp does not come on.

I would like ask you or your technicians to follow the steps below in order to check the instruments wiring harness:

• Turn instrument off
• Remove covers (see photos in attachment- please note that the attachment contains instructions for replacing a component, do not remove any parts of the instrument just visually inspect components)
• Visually check the wires that connect to the door switch and the wiring from the Lamp to the Lamp Control Board.
• If any brown outs are detected, please take photos and send them to us.

**If the Lamp Control Board shows signs of brown outs or it is damaged the instrument will have to come to our Lab for replacement of the board.

Was this article helpful?
0 out of 0 found this helpful

Comments

Powered by Zendesk