Use of EasyMatch QC with Multiple Instruments

Follow

FAQ: "Can a single instance of EasyMatch control more than one instrument? Or can a single computer run multiple instances of the EasyMatch with each instance connected to a single instrument?"

EasyMatch QC is a software platform that can be used with any of HunterLab's laboratory and portable sensors. Just load the different sensors under Sensor/Install-Configure and switch from one to the other by selecting the sensor as the active one, again under Sensor/Install-Configure. The sensor in use will be found in the sensor information line at the bottom of the EasyMatch QC screen.

A single computer can only be used with one instance or version of EasyMatch QC at a time.

 

 

 

Was this article helpful?
0 out of 0 found this helpful

Comments

Powered by Zendesk