This CMR replaces the standard calibrated white tile with a white disk that fits inside the ring and disk assembly.

Important Notes:

Installation:

Reading Samples with ColorFlex EZ

1. From the MAIN MENU, select STANDARDIZE using the UP and DOWN arrows and then pressing the GO The Standardization screen appears prompting for the black glass.

2. Place the Black Glass on the measuring sample cup measuring port with the shiny side of the glass against the port. Check that the Black Glass is flat and in solid contact against the port and that the white dot is facing forward towards the operator.

3. Press the GO The ColorFlex EZ reads the glass and sets the instrument zero or bottom-of-scale. When it is finished, the screen prompts for the calibrated White Tile.
4. Replace the Black Glass with the sample cup with the calibrated white disk in the bottom.

5. Press the button GO. The ColorFlex EZ reads the White Tile and sets the top of scale. When it is finished, the screen indicates that the instrument has been successfully standardized.

6. Remove the calibrated white tile when standardization is completed. Click OK.
7. Select READ from the ColorFlex EZ's main menu. Move the cursor to highlight its position using the UP and DOWN arrow buttons and then press the GO.
8. The first Reading screen appears, for setup selection. To read the last product setup used, press NO (down arrow) and skip to Step 4. To select the setup for use from the list of setups, press YES (up arrow), and select the setup.

9. Scroll through the list of setups using the UP and DOWN arrow buttons until the desired setup is highlighted. Then press the GO button to use that setup.

10. Place the standard or sample at the sample port in the sample cup, ring and disk assembly.

11. Press the GO button to read. The standard or sample is read and its values (as configured in the product setup) displayed on the screen.

Do you still need more information? Submit a ticket and our support team member will reach out to you soon!